close
close

How To Light Pilot On Heatilator Gas Fireplace

th 1813

How To Light Pilot On Heatilator Gas Fireplace. Is it dangerous if pilot light goes out on gas. Gas fireplace operation manual gas fireplace fireplace.

36" Natural Gas Pilot Assembly With Thermocouple Fire
36" Natural Gas Pilot Assembly With Thermocouple Fire from www.fire-parts.com

Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts. These should be toward the bottom of the unit and. How to light gas logs in fireplace?

It Is Usually Located Behind The Logs And Is Responsible For Starting The Fire.

Can an open fireplace heat? Follow these steps to light the heatilator gas fireplace’s pilot: To light burner, turn knob counter clockwise t.

Once The Pilot Lights, Keep Holding Down The Gas Control Knob For 20 To 30 Seconds To Allow Time For Heating Up The Thermocouple (A Safety Device), Then Release The Knob So It Pops Back Up.

Most gas fireplaces rely on a “continuous pilot light,” a type of pilot that remains lit so long as gas is flowing to the unit. Push in the pilot knob, which manually sends gas into the system. If the pilot does not light, wait 5 minutes and try again.

Fireplace, Heatilator, Piolot Light, Gas, Natural Gas, Propane, House Fireplace, Insert Fire, Burners,

How to light your pilot light on a gas fireplace | heatilator a2fwkswou4kbhbrh15304lis How a lot does it price to maintain the pilot light on a gas hearth? Either a constant pilot mode or an intermittent pilot mode is used by electronic ignition systems.

While Still Pushing On The Knob, Press The Igniter Several Times Until It Fires.

For more information visit ht. Is it dangerous if pilot light goes out on gas. If the pilot light goes out, you’ll just need to dig deeper.

Press And Hold Down The Gas Control Knob, Then Press The Igniter Button Multiple Times, As Needed, Until The Pilot Flame Ignites.

The great thing about a gas fireplace is that it is easy to light and works quickly to heat up your home. The pilot position on a gas fireplace is the position on the fireplace controls that is used to start the pilot flame. If you have a continuous pilot light system, you should always see a pilot flame unless you have manually turned the system off.

Leave a Reply

Your email address will not be published.